Community Hub
Knowledge Articles
Visit Forums
Article
How to obtain an access token for the onsemi coil design tool for NCS32100 when it has not been received.
Forum
Inquiry about the setting parameters of the inductive position sensor design tool for the rotor and stator PCB included in the NCS32100-GEVK
Forum
NCS32100 Connection to Stator Coil Pattern
Forum
How should REC[3:4] be connected in the sensor coil configuration?
Forum
Hello, I found a discrepancy in the NCS32100 datasheet – Pin 13 is shown as GND in the QFN40 pinout diagram, but in Table 1 it is listed as NC. Which one is correct?
Forum
Is source code available for the NCS32100 firmware or is there a compiled version that implements SPI port comms?