The FD3501 is a high performance 8 phase digital buck controller which can be configured for single or dual rail output rails. It is fully compatible with Intel® SVID protocol. It is designed to power Intel’s VR13 and VR13.HC processor rails, DDR memory DIMM banks and high current low voltage digital loads. All of the required parameters are programmable through the PMBus interface.
The FD3501 device uses onsemi’s proprietary Advanced COT architecture to implement control and power management functions with maximum flexibility, performance and minimal controller and overall solution size. The Advanced COT control features extremely low latency against severe load transients and easily permits a high switching frequency design with ceramic only output capacitors. Non−Volatile OTP Memory is included to store multiple custom configurations. It also achieves the best platform efficiency by implementing fast−to−change dynamic phase management and a variable frequency light load control.
The FD3501 device is designed to be used with onsemi's smart power stage 3 and 4 (SPS3 and SPS4) generations of parts which accurately integrate inductor current sensing and temperature monitoring.
搜寻
Close Search
产品:
1
分享
排序方式
产品系列:
┗
可订购器件:
1
产品
状态
CAD Models
Compliance
Package Type
Case Outline
MSL Type
MSL Temp (°C)
Container Type
Container Qty.
ON Target
Topology
Phases
Control Mode
VCC Min (V)
VCC Max (V)
fSW Typ (kHz)
参考价格
Show More
1-25 of 25
Products per page
Jump to :
支持服务
联系安森美销售团队获得支持,查询或者对比产品细节。
联系销售
分享
导出
Rows
Printer Friendly Version
PDF Format
Excel Format
CSV Format
To proceed order you need to accept Terms
可靠性数据
Die Related Summary Data
Device: FD3501MNTXG
Equivalent to wafer fab process: ONC18
产品技术
产品技术
等效器件小时
平均故障间隔时间/平均无故障时间(按小时计算)
FITS
ONC18
5
11214429642
More Details
Re-calculate Data
Data is based on the following assumptions.
Note: The temperature and confidence level may be adjusted to your requirements.
Disclaimer: A reliability FIT rate calculated using this tool shall not be used for any functional safety purpose. In case a raw FIT rate needs to be estimated for a component which is targeted to be used in a safety critical application (i.e. compliant to ISO 26262 standard) it should be calculated according to generic safety standards (IEC62380, IEC61709, SN29500, FIDES, etc.)