Generation 4+ of our intelligent LED drivers is targeting Front lighting LED driver modules for legacy Domain Architecture as well as the emerging Zonal Architecture for Software Defined Vehicles (SDV) with 10Base-T1S.
NCV78902 - a two-phase booster provides complete solution for automotive front lighting applications when paired with buck LED driver (current source). Designed for high current LEDs in front lighting application like low beam, high beam, turn indicator and more. Two devices can be combined and operate together as a multi-phase booster. This allows to further optimize the filtering effect and allow cost effective dimensioning.
The device enables Current sensing on Shunt Resistor or MOSFETs' RDSon, allows for Stand-alone or Limp home modes, incorporates built-in Programmable Soft-Start and especially brings superior stability and response time even with small output capacitance. The device is designed to operate at frequencies up to 2 MHz to allow for small inductor sizes and at the same time to keep EMC under control.
The NCV78902 can be operated in SEPIC mode - Output voltage can be lower than input voltage (car battery).
Thanks to the SPI programmability, one single hardware configuration can support various application platforms.
搜寻
Close Search
产品:
1
分享
排序方式
产品系列:
┗
可订购器件:
1
产品
状态
CAD Models
Compliance
Package Type
Case Outline
MSL Type
MSL Temp (°C)
Container Type
Container Qty.
ON Target
Topology
VIN Min (V)
VIN Max (V)
VO Max (V)
IO Max (mA)
fSW Typ (kHz)
参考价格
Show More
1-25 of 25
Products per page
Jump to :
支持服务
联系安森美销售团队获得支持,查询或者对比产品细节。
联系销售
分享
导出
Rows
Printer Friendly Version
PDF Format
Excel Format
CSV Format
To proceed order you need to accept Terms
可靠性数据
Die Related Summary Data
Device: NCV78902DE0R2G
Equivalent to wafer fab process: I4TE
产品技术
产品技术
等效器件小时
平均故障间隔时间/平均无故障时间(按小时计算)
FITS
I4TE
3
6620906392
More Details
Re-calculate Data
Data is based on the following assumptions.
Note: The temperature and confidence level may be adjusted to your requirements.
Disclaimer: A reliability FIT rate calculated using this tool shall not be used for any functional safety purpose. In case a raw FIT rate needs to be estimated for a component which is targeted to be used in a safety critical application (i.e. compliant to ISO 26262 standard) it should be calculated according to generic safety standards (IEC62380, IEC61709, SN29500, FIDES, etc.)