The NCP81295 and NCP81296 are hotswap controllers with a low on resistance MOSFET (0.65mohms). These devices provide overcurrent protection during short circuit and overcurrent condition. It low on resistance reduces losses and the current is monitored by the internally current mirror, thus eliminating the need for a sense resistor, thereby saving power and cost. These devices can be paralleled for higher current conditions. Robust soft operating area performance helps minimize the number of paralleled device in higher current applications. The NCP81295 offers latch off during overcurrent while the NCP81296 offers hiccup operation. Both parts are offered in a thermally enhanced 5mm by 5mm QFN package.
搜寻
Close Search
产品:
1
分享
排序方式
产品系列:
┗
可订购器件:
1
产品
状态
CAD Models
Compliance
Package Type
Case Outline
MSL Type
MSL Temp (°C)
Container Type
Container Qty.
ON Target
Over Current - Shutdown (Y/N)
Over Current - Current Source (Y/N)
Current Limit (FIXED/ADJ/NO)
Over Voltage Protection (Y/N)
Reverse Current Blocking (Y/N)
FAULT Signal (Y/N)
PGOOD (Y/N)
UVLO (Y/N)
Rds(on) Typ (mΩ)
Max Current (A)
Output Discharge (Y/N)
IMON Output (Y/N)
Adjustable Slew Rate (Y/N)
Vin Min (V)
Vin Max (V)
Iq (µA)
eFuse / Hot Plug (Y/N)
Input / Output
Product Family
参考价格
Show More
1-25 of 25
Products per page
Jump to :
联系安森美销售团队获得支持,查询或者对比产品细节。
联系销售
分享
导出
Rows
Printer Friendly Version
PDF Format
Excel Format
CSV Format
To proceed order you need to accept Terms
可靠性数据
Die Related Summary Data
Device: NCP81296MNTXG
Equivalent to wafer fab process: ONC25
产品技术
产品技术
等效器件小时
平均故障间隔时间/平均无故障时间(按小时计算)
FITS
ONC25
2
7241242698
More Details
Re-calculate Data
Data is based on the following assumptions.
Note: The temperature and confidence level may be adjusted to your requirements.
Disclaimer: A reliability FIT rate calculated using this tool shall not be used for any functional safety purpose. In case a raw FIT rate needs to be estimated for a component which is targeted to be used in a safety critical application (i.e. compliant to ISO 26262 standard) it should be calculated according to generic safety standards (IEC62380, IEC61709, SN29500, FIDES, etc.)